These powerful machines can be a very good thing with regard to cleaning your deck. Here’s our device for cleaning your deck.
The pressure washer makes a satisfying and quick work of carpeting away from the gunk. For stripping old paint from the deck and cleaning walkaways, nothing rivals the unbridled power of the incredible pressure washer.
You may be inclined to pressure wash almost everything around your house. However, you should be very careful because the supercharged water stream can etch or nick wood and damage paint.
Before deciding to use a pressure washer to wash your deck, it is important to determine whether it actually makes sense to clean your deck using the pressure washer and when the scrub brush and a garden hose will suffice.
Regardless of the performance of a pressure washer, we only recommend using the models that exclude the 0-degree nozzle that we strongly believe causes all the unnecessary safety risks to bystanders and users.
Keep reading to find out when it makes sense to pressure wash a deck.
Should You Pressure Wash A Deck?
Yes. Decks developed from the South American hardwoods like Tigerwood, Camaru and Ipe will perfectly hold up to power. Decks that are made of wood that has already been pressure treated are typically okay, assuming that you will not hold the nozzle too close to the wood.
Typically, pressure-treated wood refers to the southern yellow pine that is very soft, therefore, it makes sense, to begin with, and the low-pressure nozzle on the inconspicuous spot to ensure the spray is not marking or etching the wood.
You may want to verify with your manufacturers manual to determine the nozzle and the settings the maker recommends for deck cleaning and how far from the surface you should keep the nozzle. In any case, it would be great if you work alongside the length of the board.
The pressure needed to clean the surface of your deck is rarely over 1,500 PSI. Nevertheless, this is still sufficient to damage the softwood and adequate pressure to cause lap marks on the composite decking.
Keep in mind that when it comes to pressure washing, less is more. Usually, a pressure washer works as a mechanism for removing the embedded dirt and other contaminants.
Why Use A Pressure Washer?
Pressure washers are very popular among homeowners. These tools come in different sizes. The end of the spray wand may be fitted with different tips, which concentrate the high-pressure water stream in different ways.
It is this water stream that cleans through agitation of the surface of anything it strikes.
A pressure washer can quickly clean the wood deck much easier than scrubbing it by hand. This is an incredible advantage. Nevertheless, the pressure washer will often destroy the wood surface.
The water stream can be very powerful to the extent of eroding the light-colored fibers of the springwood. The fibers that are not eroded could be dislodged, leaving the wood rough or fuzzy after it dries.
However, professional desk washers have argued that this can only happen when an inexperienced user is using the tool to clean and the pressure is too high, the tip is held very close to the surface of the wood or the wrong nozzle was used.
Therefore, before using a pressure washer, it is always important to start by testing it so that you can rest assured that you will use it without damaging the wood.
Keep in mind that a pressure washer cannot be used to clean all types of decks. The most modern decks from reputable brands such as Trex and TimberTech initially resist deep staining and can only be cleaned with light scrubbing.
If the light scrub together with the garden hose rinsing is still not enough to clean your composite deck, you should check the terms and conditions of the warranty before you start using the pressure washer just to ensure you don’t void the warranty.
It is without a doubt that pressure washing a deck is a quick and effective way to make sure your deck I ready for staining or painting.
Always remain vigilant when pressure washing your deck to avoid gouging or chipping the wood. Hopefully this answered the question, should I pressure was my deck?